GaaaaaaaAAARRR! You... liittlle... @&*#%&^.....[ tantrum] = Aeroplane guys....HELP!
Being my first attempt at an aircraft Dev, I guess a few hiccups were inevitable, although I wasn't expecting one straight out of the barrier.. After lovingly texturing my Devastator model, I've discovered much of it was a waste of time ( I'll have to re-design a chunk of the 3D mesh)
Brain-strain # 1 ~ How do you get an aerofoil / wing to un-fold as a single part ? ( joined at leading edge) I've tried multiple variations ~ open ended wing tips / closed wing tips, unrealistic thickness at the wing tips ++++ ... I just can't figure out how to translate the rounded + tapered leading edge, to flat wing tips ~ so the wing un-folds as a clean 'upper and lower surfaces' etc. Is there a trick to it?, or is it a limitation of the META / PEP combination.. ( + designer).. is there a post addressing this problem/design issue anywhere.?
I'd be grateful for any tips..
wall1