Hello Everyone,
I have a loop within a loop setup. My inner loop has a reverse loop (I've seen it described as an 'across' on other websites). The first picture shows how it is currently configured on my layout by using one power pack + an Atlas Selector. It works fine, but means that I have to make many changes on my selector in order to have it operate smoothly. Sometimes it gets very confusing for me because there are so many selections, especially if the train has to enter the loop/across from the opposite direction.
So I saw that Atlas has a product called "controller #220". I read on the Atlas website that this product is good for reverse loops and wyes so bought a couple to see whether it can simplify my operations. My problems are :
(1) the instructions that came on the back of the Atlas package are very confusing and doesn't seem to correspond to my layout especially considering that they show 2 powerpacks + at least 1 "Atlas selector" are needed, and
(2) I can't find any useful information on the web about how to wire it. Most of the websites contain information about how to wire such things with switches you buy at Radio Shack (DPXX, etc).
My problem is I'm in Thailand and we don't have anything like Radio Shack so I cannot just run out and buy things like that.
I was wondering if it is :
1) possible to wire the Atlas controller using just one powerpack thus allowing for the trains to go though the turnouts without jumping?
2) if so, how do you wire it? (the instructions on the back display it alongside with an Atlas "Selector", but if I can get the same results with simply using 1 selector + 1 power pack then why do I need to have the "Controller" in the first place?
I am not looking for an automated sytstem and don't mind pushing a few buttons/switches while the train is already inside the reverse loop / across. But perhaps pushing one or two buttons while te train is inside the reverse/across loop should be enough.
Any information you all could offer would be most appreciated. Picture #2 is what I would like to end up with if possible.
Thanks to you all. You've all been very helpful to me through other problems.
Douglas
I have a loop within a loop setup. My inner loop has a reverse loop (I've seen it described as an 'across' on other websites). The first picture shows how it is currently configured on my layout by using one power pack + an Atlas Selector. It works fine, but means that I have to make many changes on my selector in order to have it operate smoothly. Sometimes it gets very confusing for me because there are so many selections, especially if the train has to enter the loop/across from the opposite direction.
So I saw that Atlas has a product called "controller #220". I read on the Atlas website that this product is good for reverse loops and wyes so bought a couple to see whether it can simplify my operations. My problems are :
(1) the instructions that came on the back of the Atlas package are very confusing and doesn't seem to correspond to my layout especially considering that they show 2 powerpacks + at least 1 "Atlas selector" are needed, and
(2) I can't find any useful information on the web about how to wire it. Most of the websites contain information about how to wire such things with switches you buy at Radio Shack (DPXX, etc).
My problem is I'm in Thailand and we don't have anything like Radio Shack so I cannot just run out and buy things like that.
I was wondering if it is :
1) possible to wire the Atlas controller using just one powerpack thus allowing for the trains to go though the turnouts without jumping?
2) if so, how do you wire it? (the instructions on the back display it alongside with an Atlas "Selector", but if I can get the same results with simply using 1 selector + 1 power pack then why do I need to have the "Controller" in the first place?
I am not looking for an automated sytstem and don't mind pushing a few buttons/switches while the train is already inside the reverse loop / across. But perhaps pushing one or two buttons while te train is inside the reverse/across loop should be enough.
Any information you all could offer would be most appreciated. Picture #2 is what I would like to end up with if possible.
Thanks to you all. You've all been very helpful to me through other problems.
Douglas