I started to assemble the P2K 8000 gallon tank (the "full" version, not the time-saver) last night.
I managed to break about 1/2 of the grab irons, despite following their instructions about cutting them from the sprue, widening the holes for an easier fit, etc, etc.
Am I missing something here? Is there anther approach I could use to increase success / decrease breakage?
In a related question - does anyone know if a set of wire grab irons are made for this kit?
Thanks!
Andrew
I managed to break about 1/2 of the grab irons, despite following their instructions about cutting them from the sprue, widening the holes for an easier fit, etc, etc.
Am I missing something here? Is there anther approach I could use to increase success / decrease breakage?
In a related question - does anyone know if a set of wire grab irons are made for this kit?
Thanks!
Andrew