Hey all,
2" foam resting on "bed frame" benchwork (95% of the foam is accessible from below)
Atlas #65 (or #66) switch machines.
Idea #1) Extending the throw pin somehow, but was not sure what the best way to do this was.
Idea #2) Digging into the foam about 1 1/2". Not sure what the best way is to do this.
Idea #3 - whatever) -- your responses...
Thanks,
Scott
2" foam resting on "bed frame" benchwork (95% of the foam is accessible from below)
Atlas #65 (or #66) switch machines.
Idea #1) Extending the throw pin somehow, but was not sure what the best way to do this was.
Idea #2) Digging into the foam about 1 1/2". Not sure what the best way is to do this.
Idea #3 - whatever) -- your responses...
Thanks,
Scott