Ok, here we go again with my build of the Master's model. To start off as always, i print on 11x17 paper. Alot easier for me to roll and see.( getting younger each year). The spine is a 7/16 wooden dowel at 4' long..( i know, "4 foot...is this guy nuts??) . cutting and rolling out the pieces for the spine wasn't too bad
after gluing them to the dowel it left a small gap. so i cut a trough to run wires the entire length.
glued into place
after gluing them to the dowel it left a small gap. so i cut a trough to run wires the entire length.
glued into place
Attachments
Last edited: