I need to put up sides, about 3-4 inches high on some of my benchwork because the track gets very close to the edge. I am not a carpenter and I would love some advice on the best way to do this.
Thanks.
Thanks.
I had not even thought that my GodSon will get a kick out of these trains. Thanks for the tip, he's a good kid, but a little rambunctious as are most 4 year olds.revandy said:I mount 3/8" clear plastic sheeting approx 6-8" high, it keeps little fingers away and saves the rolling stock from taking a header onto my concrete floor.
bobaloo000 said:btw, I got to 1 1/2 by addin 3/8" plexi + 3/4" plywood. Forgot I was going INTO the plywood.
and use a screw driver (not a battery drill) making slow turns to snug it up. i am an expert at running the screw up to tight and cracking the plexiglass.sumpter250 said:3/4" X 8 screws would work well. drill pilot holes in the wood, and clearance holes in the plexi. (or countersunk, if you use flathead screws)
Pete