E-Z Command?

Discussion in 'DCC & Electronics' started by 13Mtrainer, Jun 12, 2005.

  1. 13Mtrainer

    13Mtrainer Member

    i have seen this product in the MR and i was wondering if it was any good. it is DCC and looks pritty good it is only $95?
  2. cidchase

    cidchase Active Member

    It will not program decoder CV's. If you have a factory decoder-equipped loco it should
    be fine. If you have some other system to do programming you can use the EZ-command
    to run those other locos or decoders. It works fine and you can get it for under USD 50.00.

Share This Page