cylon eye bike light--kit the night rider car eye light

Discussion in 'Science Fiction & Fantasy' started by spaceagent-9, Sep 24, 2014.

  1. spaceagent-9

    spaceagent-9 Right Hand Man and Confidant

  2. ASC Mclaren

    ASC Mclaren Member

    I saw some fairly easy looking schematics for the "Larson eye" effect using ic555 timers while researching my police circuits.
  3. zathros

    zathros -----SENIOR---- Administrator

    I like the way this works, and it is a simple design.

    From this website (scroll to bottom of page):


    40 LED Bicycle Light
    The 555 circuit below is a flashing bicycle light powered with four C,D or AA cells (6 volts). Two sets of 20 LEDs will alternately flash at approximately 4.7 cycles per second using RC values shown (4.7K for R1, 150K for R2 and a 1uF capacitor). Time intervals for the two lamps are about 107 milliseconds (T1, upper LEDs) and 104 milliseconds (T2 lower LEDs). Two transistors are used to provide additional current beyond the 200 mA limit of the 555 timer. A single LED is placed in series with the base of the PNP transistor so that the lower 20 LEDs turn off when the 555 output goes high during the T1 time interval. The high output level of the 555 timer is 1.7 volts less than the supply voltage. Adding the LED increases the forward voltage required for the PNP transistor to about 2.7 volts so that the 1.7 volt difference from supply to the output is insufficient to turn on the transistor. Each LED is supplied with about 20 mA of current for a total of 220 mA. The circuit should work with additional LEDs up to about 40 for each group, or 81 total. The circuit will also work with fewer LEDs so it could be assembled and tested with just 5 LEDs (two groups of two plus one) before adding the others.

    ASC Mclaren and Rhaven Blaack like this.

Share This Page