C&S #70 In On30

Discussion in 'On30 Forum' started by loggeron30, Oct 3, 2005.

  1. loggeron30

    loggeron30 New Member

    Here is a bash from a Bachmann HO 2-8-0 that I did. For the most part, just the drive train was used. Made the boiler and tender, and used PSC detail parts for everything else. It was a project, but one I am glad I did.
    Hope you enjoy,

  2. sumpter250

    sumpter250 multiscale modelbuilder

    :thumb: :thumb: :thumb:
  3. DanishKnight

    DanishKnight Member

    Ken, that's a great looking Consolidation, and layout!
  4. Tileguy

    Tileguy Member

    Ken, as always your work is superlative :)
    welcome to the gauge by the way !!
  5. loggeron30

    loggeron30 New Member

    Many thanks for the kind words, gents!
  6. Dragon

    Dragon Member


  7. loggeron30

    loggeron30 New Member

    Gotta jog my memory as it was about 5 years ago when I did this but for the most part it is just a piece of PVC for the boiler, PSC detail parts and a Grandt Line Cab.....(thinking back I should have used a PSC Cab). The tender itself is just styrene shapped and rivet detail added to it. The drive tain is a Bachmann HO 2-8-0 without any modifications to allow the fit of the boiler. Had to make a small sub-frame for the cab and if memry serves correct it was about a three evening project.
  8. Chessie6459

    Chessie6459 Gauge Oldtimer

    Nicely Done Ken.:thumb: :thumb: :thumb: :thumb: :thumb:

Share This Page