Hello,
I have installed bus wiring under the layout, attached Zephyr set and am running trains.
The bus wiring is 14 guage and consists of 2 wires, a black and a red and they run parallel to each other down the center of the layout. I did twist them together every now and again.
I connected the Zephyr to these bus wires at approximately mid point.
My question: The ends of the wires (both ends) are connected to
small terminal blocks which have no connection to anything on the layout. I did that because I just didn't want the ends of the wire "exposed". Since everything is running well I assume this is okay. Any comments.
I assume they do not have to come back together in a complete circle?
Thanks
John Q
I have installed bus wiring under the layout, attached Zephyr set and am running trains.
The bus wiring is 14 guage and consists of 2 wires, a black and a red and they run parallel to each other down the center of the layout. I did twist them together every now and again.
I connected the Zephyr to these bus wires at approximately mid point.
My question: The ends of the wires (both ends) are connected to
small terminal blocks which have no connection to anything on the layout. I did that because I just didn't want the ends of the wire "exposed". Since everything is running well I assume this is okay. Any comments.
I assume they do not have to come back together in a complete circle?
Thanks
John Q