A Pre-Fab Scratch

Discussion in 'Scratchin' & Bashin'' started by Sir_Prize, Jun 19, 2003.

  1. Sir_Prize

    Sir_Prize Member

    Evening all...
    Too tired to get off this one track I'm on...
    What side would I scribe of a sheet of Evergreen Styrene
    "Metal Siding"to make a window? Or do I just make the "X" cut
    for the window and carefully push the resulting triangles
    (as much as possible) straight back?

    I'm sure ya'll talked about it...
    I'm just to dern tired ta hunt fer it rite now...

  2. leghome

    leghome Member

    My thinking because I have never done this wouold be to scribe it on the outside so it would give a clean appearance to the break. I have carefully used my exacto knife to cut all the way through but keeping it straight is a hard job .

Share This Page