which is better?

Discussion in 'RC General & Getting Started' started by monsterrcbuilder04, Aug 13, 2004.

Thread Status:
Not open for further replies.
  1. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    Airtronics 94102 -
    NEW
    Transit Time: .22 seconds/60 degrees
    Torque: 50 oz/in

    Hi-Tech HS 425 BB dual ball bearing servo –
    Used but in perfect operating condition.
    Transit Time: .20 sec’s
    Torque: 43.4oz/in
  2. redheat

    redheat Member

    I would go with the Air because it is new , dont like used electric stuff. That air comes with metal gears to I believe. are you planning on using it for a steering servo? RED
  3. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    yes.o and would it fit in my evader?i know you didnt list it but its a good deal and i will buy it if it will fit.THANX
  4. redheat

    redheat Member

    It'll be very close in size not sure how much room you have to work with.L-1.54, W-.79 H-1.42 on the 94102 Air/ Now the one that is made for it goes like this, L-1.6, W-.8, H- 1.5 , all in inches. that was the Futaba. Do some measuring , if I had it I could make it work. If it does fit I found another one Futaba S3305 high torque. RED
  5. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    ok ill measurte it cause that air is only $11 shipped.good deal,huh?
Thread Status:
Not open for further replies.

Share This Page