Ok, I have completed Voltron's toe, so I am moving on to the leg. But I have pictures of the stages every once in a while. As you said, that section needed to be thicker, and my A4 paper is an average thickness, and feels paltry after using 32lb paper. So what I did was use a glue stick and glue said sections to a piece of my thick paper. Once I glued the sections together, it became insanely thick, but it fufilled its purpose. After I glued the sections together. Side view, where you can guess at its thickness. The Bottom, everything didn't line up perfectly, but I made due. The front view of the completed toe. Side view of the toe. I also reinforced and weight-bearing areas on the model, mainly the bottom and back to prevent it from caving in at any point. This is very large, about 3 or 4 inches long, and aboutthe same tall. So, I'm already at work on the lower leg, so I hope to post my progress again soon. EDIT: Forgot to resize the pictures, but it's fixed now.