track connection

Discussion in 'DCC & Electronics' started by madmez, Jan 17, 2006.

  1. madmez

    madmez New Member

    will it do any harm to ballast in the soldered track supply connections once they have been made and tested?
    or could it cause problems?
    on a dcc layout with lenz controller.
  2. MasonJar

    MasonJar It's not rocket surgery


    Will not hurt it, unless you are using some sort of electrically conductive glue. Just remember to have the power unplugged when you actually do the ballasting, and while everything is drying.

    Before you do it though, make sure that everything runs just right...!

  3. madmez

    madmez New Member

    just normal pva glue will be used.
    50-50 water and a drop of the good old washing up liquid!!
    will leave plenty of drying time!

Share This Page