The BMP-1 Puma- Project

Discussion in 'Armory & Military' started by gmeyer1962, Jun 21, 2010.

  1. named50

    named50 New Member

    Impressive work, wonderful job! considering that the parts were so small (no not small it's sooo tiny).

    I guess I'll try simpler one :mrgreen:
  2. gmeyer1962

    gmeyer1962 Member

    to MAGI:
    I did that thing during April and August 2010. I've had stresses at my job , so needed
    some time to relax. My paperhobby gave it to me. Several layer glued together of cornflakes-boxes and the like. that gave me the 2mm basic structure as required by
    the plan. Printing was done on very normal 80g/m² printing-paper. My laserprinter
    can not handel more than 120g/m² .
    so almost every part is doubled means glued on another paper or cardboard to achieve
    the needed thickness

    The Model can be found at :
    scroll down
    Its a polish model. I could not read the instructions but i have good enough
    experience to finish it. As you see above.....:lol:

    Thank you all for the compliments.

  3. smelter273

    smelter273 New Member

    The attention to detail is astounding. Please keep on building.
  4. gmeyer1962

    gmeyer1962 Member

    ... and i will do so....

    ....stay online folks and wait a while ....
  5. Fishcarver

    Fishcarver Active Member

    A Fabulous Piece of Work!

    MANY, many thanks for this most impressive build thread! Your work is amazing!
  6. goodduck

    goodduck Active Member

    I'm exhausted just watching your WIP. You need a vacation.
  7. gmeyer1962

    gmeyer1962 Member

    haha then relax when you are exhausted my friend.

    There will be another TANK .

    and i am planning to scratchbuild the escape pod from Starwars.
    But that's for the future.

    best regards

  8. BigBadBull

    BigBadBull New Member

    awesome looking tank, great detail
  9. Noddy4000

    Noddy4000 New Member

    Superb work. Love the level of detail on it.
  10. mickey5hins

    mickey5hins New Member

Share This Page