T-maxx help!!!!

Discussion in 'RC Offroad Forum' started by ty007cars, Mar 31, 2004.

Thread Status:
Not open for further replies.
  1. ty007cars

    ty007cars Member

    i have a tmaxx. It runs great and gos fast,but when i hit the brake on a turn the truck stalls?? why?? please help!! thanks ty
  2. mastmec

    mastmec Member

    The idle is set too low, turn it in a little. It does idle ok right, if not check the clutch or bearings.
  3. ty007cars

    ty007cars Member

    the idle fluctuates??
  4. rockn82

    rockn82 Marx Brother

    Oh yay the joys of a 2.5 carb. LOL. Make sure that your slide is not sticking open. Making you think that your idle is set and when you hit the brake the servo forces it to fully close. I have seen it time and time again. On about 30 different Maxxes. Sticking slide. Give it a look see.
  5. ty007cars

    ty007cars Member

    i dont get it what do i do? i raised the idle up but it makes do difference? and i also clened that little blue thing that opens up?
  6. ty007cars

    ty007cars Member

  7. mastmec

    mastmec Member

    With the truck just sitting there, you hit the brakes and it dies?
  8. ty007cars

    ty007cars Member

    when i hit the brake wile sitting there it dies,when i go around a turn while driving to brake it dies?
  9. mastmec

    mastmec Member

    then your idle is set too low.
  10. ty007cars

    ty007cars Member

  11. Jshaff15

    Jshaff15 Member

    idle speed=low

    solution-make it faster
Thread Status:
Not open for further replies.

Share This Page