Stampede

Discussion in 'RC Offroad Forum' started by danny_holtermann, Mar 6, 2004.

Thread Status:
Not open for further replies.
  1. Hey I was a wonderin if a stampede needs metal gears, for stock setup, or will I be strippin gears fast
  2. mastmec

    mastmec Member

    Set your gear mesh right and you will not ever need them.
  3. that is how my friends is set up but he needed the metal gear
  4. I just wanna know if is a good truck stock too
  5. mastmec

    mastmec Member

    Another way to strip gears is to have the slipper clutch too tight.
    It's a good bashing truck.
  6. What bout for racing?
  7. ericmcgehee

    ericmcgehee Member

    i would rather buy the evader for racing rather than the stampede. they are around the same price, but the evader is faster, and i believe they are right at 200.00 on tower and you get a free quick charger. But that is just my opinion.
  8. What about for bashing what is better
  9. there is also the graphite kit how much is that
  10. Or can you turn the stampede into graphite or aluminum
  11. ericmcgehee

    ericmcgehee Member

    im not sure how much the new graphite evader is, chec towerhobbies, im not even sure they have them in stock yet, but its woth a try.or you could just buy my associated t3. im buying a t-maxx next week, and need to sell the t3 first.
  12. alisar70

    alisar70 Member

    what is stripping gears and metal gears
  13. Nitram68

    Nitram68 Member

    -Stripping gears-To have the teeth of a gear broken off or rounded off making them unable to mesh with other gears(I.E.-pinion,clutch bell,Spur gear).
  14. Metal gears make it so they are very hard to strip
  15. alisar70

    alisar70 Member

    So what if u do strip gears Wont u have to Buy new 1
  16. ya, that wouldn't work if it was stripped
Thread Status:
Not open for further replies.

Share This Page