Discussion in 'Scratchin' & Bashin'' started by DeaconF, Nov 8, 2004.

  1. DeaconF

    DeaconF Member

    I was sure I started a thread a while ago about Sylvan and mould release cleaning, however I can't find it now. What I need to know is - Is there a cleaner that I would have around the house to clean the mould release off a cast resin kit. Sylvan has a product called Resin Prep and Testors has something called Diosol. no one around me has either. is there anything else I can use??? Thanks Frank
  2. spitfire

    spitfire Active Member

    I think dishwashing detergent works. You SHOULD have that around the house! :D :D

  3. jdscales040

    jdscales040 Member

    I've built serveral Sylvan Trucks. They say to use Dio-Sol which is what I did, but be sure you use it in a well ventalated place. And don't use Dio-Sol on the styrene parts just the resin.:thumb: :cry:

    John D.
  4. Jodam

    Jodam Member

    If it's a PVA release agent warm water with dish liquid or car windscreen cleaner in it works well.
    I used PVA release on the formwork for my bay. It cleaned up well afterward.
  5. rockislandmike

    rockislandmike Active Member

    As suggested, I use warm water and dishwashing detergent for the resin stuff I do myself. It works great, I don't think it's necessary to get the expensive (and toxic) stuff.

Share This Page