re: easy way to get the abs on my wheels

Discussion in 'RC Drifting and Setup' started by rps13, Jul 9, 2004.

  1. rps13

    rps13 Guest

    easy way to put abs on my wheels without crackin the rims
  2. f1junkie

    f1junkie Guest

    I use my tire truer - I chuck the bare rim on it, and then shave a small amount off the lip so it fits nice and snug, but not too tight. Then I use thick CA to seal the deal...


  3. SpArKeY_STi

    SpArKeY_STi Guest

    I just fit them over it... and used a rubber hammer to smash it down. I was useing the stock TC3 rims and ABS "Couplings" and they fit nice and tight.

Share This Page