RC Stand

Discussion in 'RC Offroad Forum' started by rstaubach_12, Jun 16, 2004.

Thread Status:
Not open for further replies.
  1. rstaubach_12

    rstaubach_12 Member

    I saw this one made for a T-Maxx a while back and finally found some dimensions on it. You could modify this design to fit any RC rig. I've made one for my Maxx and Ultra LX. All-in-all it's about $5 worth of parts.

    [file]Maxx_Stand.bmp,4629,,0[/file]

    [file]Maxx_Stand.jpg,4629,,0[/file]
  2. rstaubach_12

    rstaubach_12 Member

    Hopefully everyone that is looking at this is opening up the file attachment that has all the dimensions and a parts list. Guess I should have mentioned that in my original post. Anyways hope everyone finds this useful. It's been great for working on my rigs. You can turn your truck, buggy, or whatever on it's side and it will hold it. It will also hold it standing straight up and down.
  3. rstaubach_12

    rstaubach_12 Member

    Don't know if anyone really cares about this or not since there haven't been any reply's but I used this stand to replace a bulkhead yesterday and it worked great.

    Put the T-maxx in with the rear end between the up rights and it held it there while I worked on the front end.
  4. jackal575

    jackal575 Member

    can u get some pics of it in use? i dont get how the truck gets held there
Thread Status:
Not open for further replies.

Share This Page