RC helicopter?

Discussion in 'RC Aircraft & Watercraft' started by fruitloop, Dec 9, 2007.

  1. fruitloop

    fruitloop New Member

    How can i program a jr2720 tx with a mini titan 3d heli.
  2. shelbys_dad

    shelbys_dad Member

    Do you have the JR2720 receiver and servos?
    If so, I would imagine it's just a matter of removing the linkage (paying attention to the linkage position on the servos) from the servos & removing the servos along with removing the receiver.
    Install the JR servos and linkage(note bold above) and then the JR receiver. Make sure you have full travel needed (adjust as needed) on your servos before flight.
    The same goes for the throttle, disconnect the motor wires and reset your ESC.
    Pop in a fresh pack and have fun.:thumb:

    I hope this answers your question, if not......well, it may help someone.

Share This Page