pull start

Discussion in 'RC General & Getting Started' started by Billmo23, Apr 16, 2005.

Thread Status:
Not open for further replies.
  1. Billmo23

    Billmo23 New Member

    hi, im new to the RC car scene, i have a RC10 GT its a pull start. It was running fine for a while then i stoped using it for a couple years and now when i wanted to start it up again, its very hard to pull. any help?
  2. dj6666969

    dj6666969 Active Member

    the engine might have seized up OR there is just no oil or lube in it any more. Buy some after run oil and take off the glow plug and drop a few drops in it and then while ur at the hobby shop pick up a new glow plug if you don't have 1 :)
  3. Billmo23

    Billmo23 New Member

    ok tried it but for some reason today its completely locked up lol first time i pulled too hard and snaped the line, i opened it up to fix it and to possably fix any knots. nothing out of the ordinary that i could see but after putting it back together it was still stuck. any ideas?
Thread Status:
Not open for further replies.

Share This Page