Discussion in 'Tutorials' started by rkelterer, Nov 1, 2004.
now fine tuning with the flaps - again, pepakure knows about both edges of a connection -
mark the edge and choose the side of the flap
the result - ready for test build
the 3d result (glue still wet when picture was taken :-D )
Thank you so much rkelterer for reposting this!
But a few points I might add:
"First atempt to unfold - horrible"
- yeah, that sums up where I am currently with Pepakura.
"first I removed the texture - that is faster - then I defined the cut lines"
- any chance you can explain this more (cut lines), its kinda like that painting show with the dude with the afro "a few swipes of my brush and bravo! we have realistic looking trees" it leaves me confused.
sorry about the very short comments 8) I tried to update that with the cut lines (please see there). if you purchased papakura designer try to practice with the simple samples. pepakura designer is a virtual cutting mat where you do not have to keep track of the connect information - the designer will help you to find edges as well as flaps. no magic at all :roll:
greetings from austria
Separate names with a comma.