New Motor

Discussion in 'Narrow Gauge Model Railroading' started by shaymaster, Aug 19, 2005.

  1. shaymaster

    shaymaster New Member

    Hi guys. I picked up a hon3 class A climax on ebay to find out that the motor was shot. Instead of making a fuss about it cause I really like this engine and would like to remotor it. I can't seem to find a motor to replace it. The old motor is opened framed 13.32mm H, 10.22 W. 28.08 L with a 7mmX2mm shaft.
    I would like to change over to a 5 pole can motor. Can anyone help or give me some direction on this? my e-mail is

    Thanks Ken K..........:(
  2. shaygetz

    shaygetz Active Member

    Chances are, these guys have already done a changeover or tutorial on it here>>> They're very helpful and will take you thrugh it step by step.
  3. shaymaster

    shaymaster New Member

    Yea, thanks Shaygetz... I've been going through all the motors and gears. I think I'm getting close but the brass spur gear on the motor shaft is giving a hard way to go.

    Thanks again, Shaymaster

Share This Page