I posted this on the Tech thread but would like to open it up here as well.
How do I test the track for the correct voltage with a multimeter? I'm running straight DC, but have no experience using a multimeter. I read the directions, but they didn't answer the basic question of what do you actually touch with the test probes? Do you only touch one rail? Both? Do you need to ground one testor while the other touches the rail? I'm just trying to figure out if the rails I soldered today are doing a better (or worse) job of carrying power along the rails than those that are not soldered yet.
- Thanks guys -
How do I test the track for the correct voltage with a multimeter? I'm running straight DC, but have no experience using a multimeter. I read the directions, but they didn't answer the basic question of what do you actually touch with the test probes? Do you only touch one rail? Both? Do you need to ground one testor while the other touches the rail? I'm just trying to figure out if the rails I soldered today are doing a better (or worse) job of carrying power along the rails than those that are not soldered yet.
- Thanks guys -