msc???

Discussion in 'RC General & Getting Started' started by monsterrcbuilder04, Apr 13, 2004.

Thread Status:
Not open for further replies.
  1. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    if i connect 2 msc will it have less chances of frying?
  2. mastmec

    mastmec Member

    Looking For...Cthulhu!

    Why would you want to do that, you would add more weight and more bulk to your truck and you would not gain any performance of the truck just have three speeds, not much control. But your answer would be probably no.
  3. timrock

    timrock Active Member

    no comment as of yet.
  4. timrock

    timrock Active Member

    dude i make machanical speed controls with no motor or cell limit.you cant kill it even if you tryed.
  5. timrock

    timrock Active Member

    how would you connect two stock ones?
  6. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    i dono. never went that far into it. i wanted to try to run 3 electric motors in my savage.
  7. timrock

    timrock Active Member

    isnt savage a Nitro?
  8. timrock

    timrock Active Member

    you can hook up 2 msc.but if you want to run 3 motors run 3 msc.6-7 cells per motor.
  9. timrock

    timrock Active Member

    if you want to run 12-14 cells per motor then hook up 6 msc.2msc per motor.for a 3 motor application.

    i know how to do all of that.
  10. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    ya its nitro. thats the whole point. i want to try and make it electric. so i cant run anymore than 7 cells on an msc?
  11. timrock

    timrock Active Member

    nah it would run too hot.you could but it wouldnt be efficient.
  12. timrock

    timrock Active Member

    36-42 cell with 3 14 turn motors.thats about 5 hp or more.that is more power than any Nitro engine but with 42 cells it would be heavier.
  13. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    ya thats what i was thinking. 7 cells per motor should be enough. thats how many an e-maxx has
  14. timrock

    timrock Active Member

    why 3 motors why not just 2?
  15. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    i figured i would get more power out of 3. i was figuring that the savage weighrd more than the e-maxx but im not sure.
  16. timrock

    timrock Active Member

    well you can run more cells per motor than 7.
  17. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    can the streak handle dual motors?
  18. timrock

    timrock Active Member

    i wouldnt even try it.
  19. monsterrcbuilder04

    monsterrcbuilder04 Active Member

Thread Status:
Not open for further replies.

Share This Page