OH! My first head went together well, however, I ended up with a little warping. It was not much so I kept it. Take your time, and most important, do not force anything. I know the small strips can be a nightmare. Assemble one at a time. Pre-shape them well and do not use water-based-glue. Some little cuts in the right places may solve torsion problems, too. Feel free to adapt the inner skeleton. If you are more comfortable with a different solution then use that. It was VERY complicated to unfold the model, I lost the textures on more than one occasion and had to start all over again. So there are some spots which I would have liked to make differently but which was impossible to do because of that. Only the Pegasus is worse (it seems that all faces have been doubled on her and removing the doubles would result in a loss of geometry and textures :-( ). However, I wish you the best of luck!:thumb: