Kyosho GX12 Engine help for complete beginner

Discussion in 'RC Onroad Forum' started by mick_wakelin, May 10, 2004.

Thread Status:
Not open for further replies.
  1. mick_wakelin

    mick_wakelin New Member

    I have just bought a second hand Kyosho RC car fitted with the GX12 engine, I have never had a RC model before and wondered if anyone would be good enough to give me an idiots guide about the engine, I am a complete novice here,

    I put the fuel in and presumably pump it to the engine with the little button on the top of the tank, (I told you I was a novice), I attach the glow heater, how long for and do I remove it before I try to start it?, there is a screw type needle valve by the air filter, what does that do / how do I set it? and finally assuming I ever get it started, how do I stop the engine? If someone has any documentation on this or can tell me what the factory setting should be then please email it to me at mick_wakelin@cnt.com

    Many Thanks

    Mick
  2. Steve M

    Steve M Member

Thread Status:
Not open for further replies.

Share This Page