Help me w/ DCC Specialties Auto Reverse Module

[TrainNut]

FINALLY!!!!!!!!!!!!!!! After only a week, I received my Zephyr command station back from Digitrax. On the invoice, it says, replaced mother board, tested, no problems found. I hooked it back up to my layout and cautiously sent out my test engine to find that the reverse loop now operates exactly as it should. Obviously something was wrong with the mother board on the command station. Thanks to all that helped! Case closed.

 

[baldwinjl]

That's great news! I guess it must have been a bit 'sensitive'.

Jeff

 

[woodone]

WOW! And it only took one week, I would say that was very good customer service. Would I be safe in guessing that there was no charge to you for the repair ?
At any rate, you are up and running again and that is the good thing.:thumb: .

 

[TrainNut]

You are correct in that there was no charge. I was optimistic as my original receipt listed it as miscellaneous merchandise and I was hoping Digitrax was not going to question that.

 

[w8jy]

Glad to see that everything is finally working right. This has been quite an ordeal for you! Now you can sit back and enjoy DCC the way it is supposed to operate. Nice to see that your story has a happy ending.