Has anyone assembled a Jordan 1911 Model T delivery van?

Discussion in 'HO Scale Model Trains' started by nachoman, Nov 24, 2007.

  1. nachoman

    nachoman Guest

    I've got the chasis assembled, and the carbody top assembeled. But when I try putting the top on the chasis, there is a small gap of about 1/32" between the bottom of the rear doors and floor of the chasis. It almost seems lite the floor is not long enough. Is there supposed to be another piece or bumper that goes in here, or have I done something wrong during assembly?

  2. doctorwayne

    doctorwayne Active Member

    Hmm. I haven't built that one, but you should be able to use a piece of .010" or .015" styrene to fill the gap. From your description, it sounds as if the gap is on the underside. Most of the Jordan kits fit together well, although some can be a bit fussy to do when the instructions are vague. The 1928 Model A has to be one of their best, and the 1940 Ford Sedan one of the worst, as far as fit goes. :rolleyes:

  3. ChadYelland

    ChadYelland Member

    got a picture?

Share This Page