FUTABA 4VF-FM

Discussion in 'RC General & Getting Started' started by C RASHTESTDUMMY, Apr 4, 2004.

Thread Status:
Not open for further replies.
  1. C RASHTESTDUMMY

    C RASHTESTDUMMY New Member

    CAN YOU RUN 5 SERVOS ON THIS SYSTEM, I WANT TO RUN ELEVATOR,THROTTLE,RUDDER,AILERONS AND RETRACTS
  2. mastmec

    mastmec Member

    NO, you will need a 6 or more channel radio, I don't know of a 5 channel. It's better to buy more than you need now, because you might want to add later.
  3. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    Ben & Jerry's Village

    can i have a reciever with more channels than my radio if i just want to use it for a speedomiter or a failsafe?
  4. mastmec

    mastmec Member

    Yes, number of channels on the RX doesn't matter. The failsafe goes inline with the throttle servo.
  5. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    ok. i wanted to get a venom speedometer for my bandit but its only 2 channel. i think i'll just put a 3 ch t-maxx reciever in it
  6. mastmec

    mastmec Member

    You can run the Venom speedo unit with a 2 channel RX.
  7. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    ok i thought you had to connect it to the reciever. does it just go to the esc or does it go inline with the serco or something
  8. mastmec

    mastmec Member

    it can go inline with the ESC
  9. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    allright that sounds good. THANX
Thread Status:
Not open for further replies.

Share This Page