Engine problems please help!!!!!!!!!!!!!

Discussion in 'RC Offroad Forum' started by Roostertailking, Jan 6, 2004.

Thread Status:
Not open for further replies.
  1. Roostertailking

    Roostertailking New Member

    [^]Hey guys I am having a problem with my engine first I kept burning glo-plugs and I was told I was running my engine too lean so I try to richen it and the engine would start then shut of after a few seconds so I decided that I would try the break in process again and now the engine start but when I try to go a little over half throttle the engine dies I am really confused and I am new at this so please help me! [?]
  2. Steve M

    Steve M Member

    It sounds like you are too rich now. When you opened the needle valve to richen it, how far did you go?
  3. Roostertailking

    Roostertailking New Member

    Well now I was trying to start all over and break it in so I closed the valved all the way then turned it out 3 turns and I just tryed to run it again and it started running and then I opened the low speed needle and it ran a little faster then it shut of again.
  4. Bloobert28

    Bloobert28 Member

    it may be ur low end
  5. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    way too old to talk about. this has ended
  6. alisar70

    alisar70 Member

    open you low end so u get more fuel then try it
  7. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    dude i think he has fixed the problem by now
  8. alisar70

    alisar70 Member

    oh when was this post
  9. monsterrcbuilder04

    monsterrcbuilder04 Active Member

  10. pimp

    pimp Active Member

    the glow plug prob is that u r ovesly not putting the washer in there like u r soupposed 2
  11. monsterrcbuilder04

    monsterrcbuilder04 Active Member

    i always out it in but i would have never thought it would make a difference
Thread Status:
Not open for further replies.

Share This Page