Discussion in 'FAQs' started by skirun14, Aug 1, 2006.

  1. skirun14

    skirun14 New Member

    Ive seen two different ways to model a cornfield so far (astro turf and Alkem brass corn) and i was wondering if anyone else has any ideas on modeling a cornfield. Thanks
  2. ezdays

    ezdays Out AZ way

    Check out the latest issue (Sept 06) of Model Railroader. There's a couple of pages on how to do this.
  3. ratjag

    ratjag Member

    Hi skirun14, Sometime ago I read an article about that, using cut up imitation mini xmas tree branches. I'll try and find it .:D
  4. sdduckguy

    sdduckguy New Member

  5. ratjag

    ratjag Member

    :wave: Hi skirun14, I've found that article I mentioned--Railmodel Journal June 1995. Basically you buy a xmas wreath, cut it into 1 1/2" long pieces, thin each of them out so they're not too bushy, hold in thin nose pliers & heat gently with hot air gun. Spray Depot Buff, plant where reqd!! Hope that helps:thumb: :D
  6. 2-8-2

    2-8-2 Member

    Yep, just read that myself. It was a very good article.
  7. skirun14

    skirun14 New Member

    thanks everyone, this helps a lot. still if anyone else has any ideas dont be shy.

Share This Page