Controlling Signals

Discussion in 'N / Z Scale Model Trains' started by tomgschilling, Mar 17, 2003.

  1. tomgschilling

    tomgschilling New Member

    I'm a Newbie in many ways and need some advice. I'm modelling in N Scale, using DCC (NCE PHP) connected to a computer, and want to control some signals.

    As a test I bought a couple of Model Power N lited signals - model 8568. They have a red and green light and have a 3-way manual switch.

    I'd like to wire them to my layout but haven't a clue as to how. I've got a couple of Switch-it decoders I could use but can't figure the wiring.

    Can anyone advise as to how to wire these things up? Thanks in advance. ...Tom Schilling
  2. scoobyloven

    scoobyloven Member

    hi tom
    good qustion you have the do you frist hav a program to run them off ?

    their is many ways to wire them in to the layout i use a switching decoder ran off my switch contacks when the switch is thrown the decoder picks it up and turns it from red to green or green to red you can go with dector control ran off a electronic board their is a thred for them here it is a web site and i use it alot to build many things for my layout i also run in n scale

Share This Page