Back Woods Sawmill

Discussion in 'Scratchin' & Bashin'' started by Vic, Nov 2, 2002.

  1. Vic

    Vic Active Member

    Not really a "scratch or bash":D Just sorta dressed up a Woodland Senics Sawmill.

    Attached Files:

  2. jon-monon

    jon-monon Active Member

  3. Jim de Bree

    Jim de Bree Member

    Up to your usual standards

    Another great model, Vic.
  4. sumpter250

    sumpter250 multiscale modelbuilder

    Nicely done, yessah, nicely done.
  5. NYCentral

    NYCentral Member

    Very Nice Vic!!
  6. Matthyro

    Matthyro Will always be re-membered

    A great looking model Vic. What scale is it?
    I sure could use something like it in N scale.
  7. Vic

    Vic Active Member

    Thanks folks for the nice compliments!:)

    Robin...Its HO scale...I think:D Kinda always had a little doubt about WS's accuracy:D but it will fit in ok:)
  8. shamus

    shamus Registered Member

    Very sweet sawmill gear Vic, nice touch the waethering.

  9. You did a really nice job, Vic ;)

    Those little sawmills were (and still are) quite common here in the Ozarks. In fact, there's one in daily operation just a few miles from my place here at the Lake. They haul oak and hickory sawlogs in by truck and cut planks from them.
  10. Vic

    Vic Active Member

    Hi Casey, Yep they're pretty common around here too. But I haven't seen a steam driven one in a long long time. Gas or diesel driven. In fact there's one for sale in the local paper today! Seems like rough cut pine lumber is all "the rage" around here right now and they cut a lot of red oak for furniture manufacturers.
  11. Shay Driver

    Shay Driver Member

    Very nice Vic, Love the weathering.
  12. Lighthorseman

    Lighthorseman Active Member

    Nicely Done!

    Another fine job! Great work. I'd love to see this once it has been incorporated into your layout.:)

Share This Page