Recent content by DWeiler

  1. D

    Using Dcc, How Can I Hook Up Lights To My Turnouts To Signal Which Direction.

    Never had yet but most of the layut is still in progress. If i need to I have it set up to use an additional booster to run the switches and lights. Dennis
  2. D

    Using Dcc, How Can I Hook Up Lights To My Turnouts To Signal Which Direction.

    Cat 5 I used Cat 5 cables for everything except the bus wires. I ran Cat 5 wires to the switches and the remaining 4 wires were tied to terminal blocks under the top near the switches. I then ran the terminal blocks back to the main board to another set of teriminal blocks for later use for...
  3. D

    Using Dcc, How Can I Hook Up Lights To My Turnouts To Signal Which Direction.

    Try again Last try for the pics Dennis
  4. D

    Using Dcc, How Can I Hook Up Lights To My Turnouts To Signal Which Direction.

    Pics Duane, I'll try these picture if they don't show I'll e-mail them to you and if you want you can load them. Dennis
  5. D

    Using Dcc, How Can I Hook Up Lights To My Turnouts To Signal Which Direction.

    Pics As soon as I can figure out how to downsize the photo I will post. Hopefully today. Dennis
  6. D

    Using Dcc, How Can I Hook Up Lights To My Turnouts To Signal Which Direction.

    Led's I am using exactly what you are trying to do on my layout and it works great. Dennis
  7. D

    What do you do?

    25 years at the Postal Service and getting out this year
  8. D

    Control Panel with Indicators

    Does anyone have a copy of the schematic drawings that COCentralRR talked about in his post, and if so could you send them to me. I have the same thought but everyting I try doesn't work. Thanks
  9. D

    DCC Wiring help

    Can antone suggest a book for wiring DCC. Have gotten 85% of track laid and need to start the wiring. Dennis
  10. D

    Sawmill Mill

    Thanks Thanks for all your help. Will try to make something somehow. Lot's of time and hopefully many years to go. Phil if you could wend that to me ot would be great. DWeiler@aol.com. Dennis;)
  11. D

    Sawmill Mill

    I am working on an early 1900 Steam layout and was wondering if anyone knew of a working sawmill available.
Top