Saturn 5 build

zathros

*****SENIOR ADMINISTRATOR*****
Staff member
Administrator
Moderator
This is one awesome model!!

sat-5-011-jpg.149383
 

lyter1958

Esteemed Member
Have you thought about maybe cutting off the flag panel section and replacing it with a "blank" panel, and insert a flag panel into the section below? I think if you print a replacement flag panel on thinner paper you could glue it over and no one would notice...?
ya, i thought of it but it's done and i like it where it's at. i gotta be different:)
 

X Sonic

New Member
Ironically, I had a big problem with that section too. I glued it on upside down, so the panel lines didn't match up. I decided to cut it off and glue it on properly, but one segment got wrinkled and looked bad. I printed out a replacement panel on the same weight paper and glued it right over the old one and it turned out pretty well - I can't tell where the replacement is anymore unless I feel along the seams to find one that is raised more than the others

ya, i thought of it but it's done and i like it where it's at. i gotta be different:)
 
Top